|
|
|
|
In reply to Post #8
cheers for the reply 
|
|
|
|
|
I use the korda spinner swivels, balancing weights and a backwards kicker on the hook. I just crimp this to a stiff boom although you can just tie a loop. I have a load of hooks with beads, kickers and bait screws ready to go and just swap them when needed.
|
|
|
|
In reply to Post #6
ah interesting thanks i was wondering about that - not sure if i trust my crimps
|
|
|
|
In reply to Post #1
If you are using a stiff material like Boom or similar I've had no problem crimping the Ronnie clip on. The tungsten sleeve still passes over the crimp and clip.
|
|
|
|
|
|
|
In reply to Post #3
As to which knot, much depends on the hook length material you are using.
If using 30lb amnesia for the boom then I use a 3-4 turn blood knot as it slides together easier.
You have to adapt to what hooklength material you want to use. A couple of pullers and give it some welly.
If the little vein in your forehead isn't throbbing then you are not really trying 
I have just checked and I think this is a 3 turn grinner. Nice and neat.
|
|
|
|
In reply to Post #2
ok thanks and 5 turn grinner onto the clip ?
|
|
|
|
In reply to Post #1
Use the esp ones, but make a little loop of very heavy shockie braid to loop onto the puller to tighten down on the small esp loop thingy.
|
|
|
|
|
whats the best quick change ronnie rig for a stiff link/boom section pls? i like the esp ronnie clips but theyre a bit fiddly to get onto a stiff link. are there any other good options?
|
|
