I have a 2 picec landing net handle I can't separate. Any ideas please?

Maybe some wd40 or silicon lubricant left to try and run down into the join

Wrap in ice for a while

Then use some rubber gloves / sheet or similar to get a good grip and then twist and pull at same time

Try a bag of frozen peas on it (or anything else cold)

In reply to Post #1
Pour some warm water over the overfit female section while trying to turn the male section loose, should work.

EDITED

My friend once told me to rub nose sweat onto the joints before putting together.

Not sure if he was pulling my whatsit or not though but i did do it for a few years and never had a problem!

In reply to Post #5
What if you don't have any nose sweat?

In reply to Post #6
Toe jam or ear wax works just as well.

In reply to Post #7

Bag of frozen peas around the joint for 20 minutes.

Get someone at either end of handle pulling / twisting while you gently tap around the joint with a wooden spoon.

In reply to Post #9
Ice trick is by far the best method.

In reply to Post #8
My thoughts exactly. It can stay as a one piece handle.

In reply to Post #11
It can't. It's a JRC net where the top section is very short and has the net attached to it. I'm going to try what you guys have advised.

In reply to Post #1
Thanks for all the suggestions. None of them worked so I took it to The Tackle Box and they sorted it for me.

In reply to Post #13
How did they get it apart?

The ice method has never failed me!

In reply to Post #13
Glad you got it sorted

Short sharp taps?