Does anyone know what pressure to put in the front fat boy tyre on my 24v carp-porter , I did a search but no joy
Tia,
Rich
Tia,
Rich
In reply to Post #1
I use 20psi in my big boy triporter as advised by prestige. I'd think yours would be the same.
I use 20psi in my big boy triporter as advised by prestige. I'd think yours would be the same.
In reply to Post #1
Is it not stated on the tyre ?
Is it not stated on the tyre ?
In reply to Post #2
Cheers
Cheers
In reply to Post #3
I've just had a knee replacement and can't kneel down to get close enough to see
I've just had a knee replacement and can't kneel down to get close enough to see
In reply to Post #5
Take a picture with your mobile phone
Take a picture with your mobile phone
In reply to Post #1
I was told 15psi buy the guys at Carp porter...but to be honest I got the impression that they were unsure themselves!
I keep the front and rear tyres at between 18 and 20 which seems to give a good compromise between compliance/firmness.
I was told 15psi buy the guys at Carp porter...but to be honest I got the impression that they were unsure themselves!
I keep the front and rear tyres at between 18 and 20 which seems to give a good compromise between compliance/firmness.
In reply to Post #1
Wheels on my PowerPorter 24v says 30psi
Wheels on my PowerPorter 24v says 30psi
In reply to Post #8
I videoed both sides of my tyre and could not see anything about pressure, googled the make and it said up to 30psi , I'll stick with about 20 👍
Cheers all for your help
Rich
I videoed both sides of my tyre and could not see anything about pressure, googled the make and it said up to 30psi , I'll stick with about 20 👍
Cheers all for your help
Rich
In reply to Post #9
Just replaced mine with these below from Amazon as got fed up with constantly having to pump them back up, also believe if the pressures are not exact tihs is what causes the power barrows to weave left or right etc....
"A Pair of 10 inch Puncture Proof PU Foam Filled Wheels Size 3.00-4 300-4 300x4 Needle Roller Bearing To Suit A 20mm Axle Shaft. Suitable For Trolleys, Sack Barrows, Jockey Wheels Carts And Wagons."
works a treat
Just replaced mine with these below from Amazon as got fed up with constantly having to pump them back up, also believe if the pressures are not exact tihs is what causes the power barrows to weave left or right etc....
"A Pair of 10 inch Puncture Proof PU Foam Filled Wheels Size 3.00-4 300-4 300x4 Needle Roller Bearing To Suit A 20mm Axle Shaft. Suitable For Trolleys, Sack Barrows, Jockey Wheels Carts And Wagons."
works a treat