In reply to Post #30
Now that sounds a great idea
Was that for the T11's or T10

In reply to Post #31
I got the spring out and it turned out to be a small piece of black rubber, if it's tightened too much it will loose its spring so the bearing that side sinks in too far.

In reply to Post #31
T11 had to send one to them for them to measure and fit ,then sent it back along with the heads they made

In reply to Post #33
Hope the picture works. No I failed

In reply to Post #33
Have you got pictures ?

In reply to Post #35
Don't know how to put them up on here ?

In reply to Post #36
Use this site; https://imgbb.com/
"html medium linked"

Follow the steps as shown in post #1184;
https://www.carpforum.co.uk/Shared/Messages.asp?TopicID=145162

In reply to Post #37
And copy the code 'html full linked' and put it in your post 👍

In reply to Post #36
Pm for you

In reply to Post #39
I don't think I'll buy any more ND stuff, all I got from someone when I enquired about it was ( All our T10s are similar, maybe we should improve it ). No help in any way.

In reply to Post #38
https://ibb.co/CPjzgLb

In reply to Post #41

In reply to Post #42
What kind of line clip have you got in that yellow head ?

In reply to Post #43
Integrated sprung ball bearing similar to the original head

In reply to Post #44
It's not a dual line clip with a fixed type as well ?