Will 10 ml of flavour + 3 ml of talin be ok for a 1 egg cork ball pop up mix 🤔

Hi hatchery carp pellets ? I have been using baitworks the edge pellets and have had great success on them he says they are hatchery feed pellets would I be right in think coppens would be a good place to start to source some hatchery feed pellets for myself

In reply to Post #55
Did you find the solar ch08 to be less firm and more comfy mate ?

In reply to Post #26
The tremors and the x series were the work of simeon bond from free spirit the later tsi model was the one he had no input in as he had decided to concentrate on free spirit only by this time I know this to be true as I contacted simeon himself to confirm given all the conflicting information on line the tremors were made out of 40 t carbon and the x series were 36 t carbon simeons reply below ⤵️⤵️⤵️

Reply from Simeon below.
Best wishes
Shaun Harrison

I developed the Tremor and the X Series but not the Tsi. That was after I had decided to concentrate only on FS. The Tremor was made in Korea and is a 40t carbon although not same as any FS rods - I wanted to keep the two ranges distinct and separate. The XSeries is 36t and was made in China. I cannot say whether the TSi series was made in the same factory as XSeries - I suspect it was and was certainly Chinese made.
Hope that helps
Simeon

In reply to Post #1
Search primal hide on Facebook they make a lovely leather one 👌👌

Doesn't if have to be a doubled ended thread grub screw ? I have just bought these pivot arms and I have the same problem I now need to attach my bobbins to the end with out the male thread on ,the grub screws I have seen are slotted and the ones I will need will have to have a point at both ends ,,any ideas chaps