Ive got a Solar pod with the A1 type buzz bars, one of the connectors for the alarms has got a slight amount of movement which is a little annoying.
Could anyone recommend any type of compound of filler that would stop the joint rocking back and forth? I've considered a metal grab adhesive ot something like that but thought it worth an ask?

Cheers

In reply to Post #1
I've never seen one of those buzz bars but if you look down inside past the tread is there a grub screw at the bottom or is it pinned, or neither? If screwed you might be able to just tighten it up.
If you go the adhesive route JB Weld is hard to beat

In reply to Post #1
give solar a call or email they will sort you out

In reply to Post #1
Mine did the same, there is a grub screw underneath, just tighten it up with an allan key.

In reply to Post #5
I'll check that, didn't think there was a screw.

Thanks

In reply to Post #6
Should be a little brass pip on the underside - which fall out if u unscrew them too much.

Can buy replacement on solar webiste