Anyone had same issue , any fixes before I consider sending it back ... been absolutely faultless up to now , cheers

In reply to Post #1
They'll tell you to clean it with a small brush. I did mine with a tooth rush and works fine now.

Daz

In reply to Post #2
That's gonna be my first try as soon as they're dry , done nowt but chuck it down 😡

In reply to Post #3
See an old thread poster had the sticking problem and found by using a bit of water or blowing on it fixed the issue.

https://www.carpforum.co.uk/Shared/Messages.asp?TopicID=433308&ReadAll=1

In reply to Post #4
Small brush dipped in wd40 worked into it , sorted. Cheers

In reply to Post #1
I have just literally had this issue. I sprayed the button with electrical contact cleaner then used an air compressor and air gun to try and blast out any grit in the button. It was better but still sticking. I then used a hook sharpening eye loupe to have a real close up look and noticed ever so slight damage to the plastic casing around the button which was fouling on the button. Used a craft knife to remove the damaged edge and all is perfect now. Worth a close up look. Couldn't see it with the naked eye.

In reply to Post #6
I'll have a look 👍