So looking around I could only really see the Jag multi tool as the only option for tightening the leavers on my micro pod
So being in the CNC world I decide to make and anodize my own.

Not claiming its any better then the Jag multi tool because its not but it fits my needs.

image

In reply to Post #1
I have the Micro Pod and am surprised you need a tool to tighten any of it especially the levers even the screws get very tight using your fingers.

Nice bit of machining all the same.

In reply to Post #1
that's looks pretty good , like that

In reply to Post #1
I reckon you would shift a fair few of them if put them up forsale

In reply to Post #1
Ah, so you are the chap who pi$$ed Jag off a few weeks ago posting this on facebook and calling it a "Tag" using virtually the same logo.....

In reply to Post #1
Much better than Jag's effort.

I'll have one off you. Send us a P.M and let us know how many quids you want

In reply to Post #6
ditto.... drop me a pm if you are selling these - ill take one

In reply to Post #1
Why would you need to buy jag gear when you can turn out something like that

I'll have one

In reply to Post #10
Nice that pm me as well if you decide to sell

In reply to Post #5
it was called j4g

As far as upsetting Jag , I had no official contact from them and my details are on FB for them to freely contact me if there was a issue, ye maybe it was to close to the bone with the name.
but I changed it anyway, didn't want to upset anyone.

as the image shows it no longer has j4g on them.

In reply to Post #2
true but I personally made it for the nut that allows you to change the 2+1's from 2 to 3 setup, then just added the other leavers to the design.

not sure about you but I find this nut comes loose when just using your hands.