I've finally updated my old attx alarms and receiver to the newer under lit versions and a v2 attx rx... problem is I can't get the receiver to pick up the alarms..:

I hold the button and it's starts flashing all lights but when I spin the wheel it's not picking it up.



Anyone got any ideas? They are closed till Monday and I wanted to use them tonight .

There are a few tutorial videos on YouTube, might be worth a look

In reply to Post #1
Make sure you have the first LED flashing, before spinning a wheel.

I think as soon as all 5 are lit you let go of the button and the first one should flash


EDIT - Mart's right

https://gardnertackle.co.uk/gardner-fishing-videos/tune-v2-attx-v2-attx-deluxe-receiver/

In reply to Post #3
Cheers I think I tried that but I'll give it another go

In reply to Post #4
I couldn't change the tone on my receiver and was convinced it was faulty, appears I was holding the P button a fraction too long so ended up in the wrong program !

Make sure the lights are behaving as they should per instructions 👍

In reply to Post #5
Still not getting it working..

All the lights flash and then when I release the button the first red light flashes but the other seem to be faintly flashing.

I'll call them Monday.

In reply to Post #6
Have you tried a new battery in the receiver?

Also try taking the battery out and leaving it for an hour.

In reply to Post #7
No but I will thanks again