Hi everyone,

I've got an older Korum Graphite Brolly that I'd like to keep using if possible.

The black pole section that fits over the stainless ground spike has snapped. The spike itself is fine, and the brolly and ribs are still in good condition, but without that pole section I can't set it up properly.

Does anyone know if this part can be replaced, or if there's a workaround to get it usable again?

Any advice would be much appreciated.

In reply to Post #2
Please can someone advise how I get the thumb?
I've been a member for years....

Hi all, anyone have 3 of these these like to sell?

In reply to Post #3
Many thanks for this.

I had this exact thought, but then worried as it's Flurocarbon if I put it on the spool correctly, will it then not transfer from one spool to the other Incorectly or the wrong way, making for bad line lay?

I have a quick question regarding Flurocarbon.

I have just bought 2 spools of 12lb kontour for my two eos 10000 reels.

Would you say I should just put this 200m straight on with no backing or would you always put backing on them?

The kontour 12 is 0.33mm and the reels say that they can take
320m of 0.33mm line.....

In reply to Post #8
Thanks so much mate! Pm sent

In reply to Post #6
Ah mate, if you did have that would be great.
Obviously I'll buy it from you.

All the very best

In reply to Post #4
Great, thanks so much.

Next problem will be finding this kit as it seems to be sold out everywhere!!!

In reply to Post #2
Cheers for the reply.

That is t the cap though,
It is the cap that goes on the underside of the buzz bar that I am missing....

Hi,

I have a fox black label pod and the middle screw on the front buzz bar has come loose because the little cap has fallen off the bottom, exposing the little screw that holds it in place.

Does anyone know if I can replace this little cap or could I buy a teeny bolt to hold the screw in place?

I have a photo but don't know how to upload it.....

Many thanks