Hi all, haven't posted on here for a LONG time so hope you're all well.
I'm basically after your opinions on the above blanks. I have 4 of the 12' 2 3/4ib blanks and 1 of the 12' 3 1/2lb blanks. They were built up but have been stripped to blanks again (I was going to have them redone but didn't do it) so look very shabby, but I dare say would clean up ok for a build. These were originally supplied as a blank from daiwa.. they aren't a factory rod that has been stripped - they carry the 'BK' prefix on the part code.
I just wondered if they still had a following or any value? Is it worth trying to sell them, or would you just scrap them? TIA
I'm basically after your opinions on the above blanks. I have 4 of the 12' 2 3/4ib blanks and 1 of the 12' 3 1/2lb blanks. They were built up but have been stripped to blanks again (I was going to have them redone but didn't do it) so look very shabby, but I dare say would clean up ok for a build. These were originally supplied as a blank from daiwa.. they aren't a factory rod that has been stripped - they carry the 'BK' prefix on the part code.
I just wondered if they still had a following or any value? Is it worth trying to sell them, or would you just scrap them? TIA
In reply to Post #1
PM
PM
In reply to Post #1
I was hoping you would get more replies about these rods i have 3 of the 3.5's thats trevs of wilmslow built with the same bk prefix.
I have been thinking of getting these rebuilt and wondered about how they compare to later daiwa rods
I was hoping you would get more replies about these rods i have 3 of the 3.5's thats trevs of wilmslow built with the same bk prefix.
I have been thinking of getting these rebuilt and wondered about how they compare to later daiwa rods