One of my Delkim plus alarms will only pair to the first channel on the receiver, whatever channel I select it always shows on the 1st one, I have tried pairing it without any other alarms and with different channels, if I chose the last channel it pairs ok but when I activate the alarm it always shows on the 1st one, so, is there a fault, or, is there something I can do to correct it, and please don't say bin it, it works fine except the pairing problem.

In reply to Post #1
Might need alarm or receiver reprogramming, speak to Delkim and they will advise.

In reply to Post #2
Thanks Dave, that is my next step, was hoping there was an easy fix

In reply to Post #3
Could you not try resetting it by wiping the receiver.Hold in button on back and switch onto l on receiver hear a pip then release then press in again until all lights come on,receiver should vibrate in your hand.If unsure go on you tube and put in reset delkim txi plus,the Danny Fairbrass video at around 4mins 20seconds shows you how to do it

In reply to Post #1
I had that but my alarms just randomly started setting my mates receiver off !
We both reset our alarms and reprogrammed them one set at a time but his receiver still picked up 2 of my heads which was weird , I got shut of them shortly after

In reply to Post #4
SOLVED

Thanks Tony, that's exactly what I did, I was a bit confused as it kept going back to the same channel, anyway after trying everything that I could think of I did the reset on the receiver (which I didn't think would work) and to my surprise all working as intended....Happy daze

In reply to Post #6

In reply to Post #7

In reply to Post #7
You're my hero.

In reply to Post #9
🖕