I've got a couple of Pin *****s in my aquatexx bivvy.
What's good to seal them up? Any resin worth using?

Thanks in advance for any replies.
MH.

In reply to Post #1
Mcnett seam sealer

In reply to Post #2
Thanks Chris...

Is it better to apply from outside or in?

In reply to Post #3
When I've had to use it I've put it on the inside

In reply to Post #3
Put masking tape on the outside, use the aquasure or seamgrip on the inside, but you must lay it flat and allow 18 hours to cure. Very lightly dust with talc to prevent and stickiness.

In reply to Post #1
Ive had the same on both my M3 and tempest brolly - I must have at some point nipped the fabric between the poles when folding them up - they look like a snake bite.

I used this kit to repair my M3 when I first noticed the holes

But I haven't bothered with my tempest brolly - its been in some atrocious downpours recently but nothing came in the two pin-***** size holes. Think they look worse than they are as they let the light in.

In reply to Post #1
Pioneer.......

In reply to Post #2
Deepens on the backing on the material, google it.