In reply to Post #1161

ive been thinking of making my own rigs like these never really knew how to do it.
quailty photo step by step guide will give it ago
cheers

In reply to Post #15

Cheers mate, helped a lot..

In reply to Post #1000
instead of doing the loop to swivel technique to get the swivel on , is it still secure to slide the swivel on the leadcore then pull the leadcore through itself

In reply to Post #1000
where do you put leadcore!

In reply to Post #1168
where do you put leadcore!


in the nearest bin

When I'm splicing leadcore I snap numerous splicing needles is there a knack to pulling the leadcore back inside itself it just seems really tight all the time and ends up with the gate of the splicing needle breaking

In reply to Post #1189
some splicing needles are just pants & no amount of care will stop them snapping!

with the ESP ones i find that rather than just trying to pull the needle through, its more a case of pushing the leadcore over the needle & teasing it through.

i still break them though!

In reply to Post #1190
Do u recommend any splicing needles Brian I've snapped a few brands

In reply to Post #1191
i just use the ESP ones.
they work for me for most of the time! i break them after a while, normally when i become impatient & try to force it!

never used any others.

In reply to Post #1192
They are about the best iv'e used also good for putting sinkers back on the wire

In reply to Post #1192
Cheers

thank you kind sir struggled for too long but no more

In reply to Post #1000
very nice thank you will be try that tomorrow