Hi thanks to the advice on here I brought a prestige power porter. Its brilliant but i am now looking to upgrade my astravan to one that I can just wheel my barrow into. I don't particularly want a massive transit type van but can anyone recommend a decent mid sized van which can take the electric barrow? Thanks
In reply to Post #1
Transit connect or Belingo. Vauxhall combo.
Transit connect or Belingo. Vauxhall combo.
Yes Berlingo/Partner/Combo vans the barrow fits perfectly, you just need to remove the handles to shut the doors, one point is try and get one with the double passenger seat that folds down into the floor and you can remove a section of the bulkhead, much easier getting the rods in when the barrow is in there.
In reply to Post #3
That looks plenty big enough, have you had any issues with electrics on the berlingo? I like the fact that the seats go down.
That looks plenty big enough, have you had any issues with electrics on the berlingo? I like the fact that the seats go down.
In reply to Post #4
I had a Partner (same van) and it was great, only problem I had with it which I didn't even notice till I went to PX it was the air-con pump needed replacing, but I think I may have knackered that driving through a flood
apart from that it was spot on
I had a Partner (same van) and it was great, only problem I had with it which I didn't even notice till I went to PX it was the air-con pump needed replacing, but I think I may have knackered that driving through a flood
apart from that it was spot on
In reply to Post #5
Oh yeah. The old “I didn't know about that” routine at trade in. We've all been there.
Oh yeah. The old “I didn't know about that” routine at trade in. We've all been there.
In reply to Post #1
I've a Fiat Doblo the L1 version and a VW Caddy Maxi. I use the VW for fishing as the extra length saves any messing about think it's about 2.2m load length. The Combo/Doblo are good vans but I'd go for the L2 version for fishing.
I've a Fiat Doblo the L1 version and a VW Caddy Maxi. I use the VW for fishing as the extra length saves any messing about think it's about 2.2m load length. The Combo/Doblo are good vans but I'd go for the L2 version for fishing.
In reply to Post #6
In reply to Post #1
Got a transit connect lwb no issues with power porter going in.
Got a transit connect lwb no issues with power porter going in.
In reply to Post #3
Hi I have an old Vauxhall combi. It had the solid bulkhead
I measured where the rods would sit when on the barrow in th e van and then marked it on the bulkhead. Removed the bulkhead and cut the square out plus a bit more out
I then used plastic sleeving for wrapping over the sharp steel edges. The rods stay on the barrow and fit through the cut out x it's not big enough for anyone to get into the back. I also nailed a piece of wood to stop the barrow going to far forward and hitting the windsceeen.
Next I made a ramp out of an old scaffold board and drilled the floor to suit two bolts Which I fitted into the board to stop the ramp moving
Finally I added two rings to the floor to let me put a bungee cord over it all to stop it tipping to one side when going round a corner
I fit the board wheel the barrow into the van, fit the bungee and remove the handles in about a minute
Same when I get to / from the lake
I am using a carp porter big wheel version
Hi I have an old Vauxhall combi. It had the solid bulkhead
I measured where the rods would sit when on the barrow in th e van and then marked it on the bulkhead. Removed the bulkhead and cut the square out plus a bit more out
I then used plastic sleeving for wrapping over the sharp steel edges. The rods stay on the barrow and fit through the cut out x it's not big enough for anyone to get into the back. I also nailed a piece of wood to stop the barrow going to far forward and hitting the windsceeen.
Next I made a ramp out of an old scaffold board and drilled the floor to suit two bolts Which I fitted into the board to stop the ramp moving
Finally I added two rings to the floor to let me put a bungee cord over it all to stop it tipping to one side when going round a corner
I fit the board wheel the barrow into the van, fit the bungee and remove the handles in about a minute
Same when I get to / from the lake
I am using a carp porter big wheel version
In reply to Post #10
Ive got a VW caddy and my mk7 power porter goes straight in with the handles left on just about fits
Had a combo previously and I had to take off the handles to fit
PS buy a motorbike ramp from eBay makes life very simple
Ive got a VW caddy and my mk7 power porter goes straight in with the handles left on just about fits
Had a combo previously and I had to take off the handles to fit
PS buy a motorbike ramp from eBay makes life very simple
In reply to Post #11
Thanks for the replies seems most middle sized vans will do the job. I like the idea of the motorbike ramp so will look at that too.
Thanks for the replies seems most middle sized vans will do the job. I like the idea of the motorbike ramp so will look at that too.
In reply to Post #12
I have a LWB connect and a motorbike ramp, makes getting the barrow in and out a breeze 😁 (although I have the Nash power barrow)
I have a LWB connect and a motorbike ramp, makes getting the barrow in and out a breeze 😁 (although I have the Nash power barrow)
In reply to Post #13
Do you have to take the handles off to get it in the connect? Nor that it's a problem really.
Do you have to take the handles off to get it in the connect? Nor that it's a problem really.
In reply to Post #14
No need for handles off in an LWB Connect
No need for handles off in an LWB Connect