|
|
|
|
 #16 10 Jun 2020 at 7.28pm | |   |
|
In reply to Post #1
Chuffy, try the nash/taska large sinkers, they work a treat for me...
|
|
|
|
|
#15 10 Jun 2020 at 11.45am | | |
|
In reply to Post #14
Korda medium sinkers matched with Korda 4mm beads. Perfect for top beads on a naked heli 
|
|
|
|
|
#14 10 Jun 2020 at 8.57am | | |
|
In reply to Post #13
You might be right there, the Korda Large Sinkers look like a better fit, still not tried them on the line though 
|
|
|
|
In reply to Post #6
They are a bit too small, they just about work if you squash the no trace bead a bit...
|
|
|
|
In reply to Post #11
Great - thanks for reply, I will give the fox ones a try
|
|
|
|
In reply to Post #10
No, they are too small, to be honest they are rubbish as well not one of Bank Tackle's finest moments for sure, just like rock hard bits of rubber 
However the Fox Tapered Mainline Sinkers/Stoppers look like they will be spot on, haven't tried them on the line yet but the bead sits nicely on sinker out of the packet so should work.
|
|
|
|
In reply to Post #7
Hi mate. Did this work?
|
|
|
|
In reply to Post #8
Nope sorry can’t find it anymore
Don’t want to send you on a wasted half hour search so deleted*
|
|
|
|
@ chamenie
do you mean THESE
|
|
|
|
Thanks for the suggestions all I'll take a look
Just ordered some large sinkers from Bank Tackle maybe they'll do
|
|
|
|
In reply to Post #1
I think fox do a tapered tungsten sinker that will take the no trace beads
|
|
|
|
In reply to Post #1
I use the Korda Large Tungsten Sinkers with a No Trace Bead.
|
|
|
|
In reply to Post #3
drennan float stop with a 5mm bead works or just a larger version of the stop, line breaks and it pulls straight off.
only need 1 bead then
|
|
|
|
In reply to Post #2
That sounds like a crafty idea, bit of a faff though to be honest, I'm sure someone must know of a sinker that's available that does the job or is everyone just buying the 3 packs every time 
|
|
|
|
|
Iv managed it by putting a tiny bit of putty on the line then putting shrink tube over the top and shrinking it down, seems to work OK.
|
|
