|
|
|
|
In reply to Post #9
Cheers for the reply fellas
Might give Customs line clips a swerve then
|
|
|
|
In reply to Post #8
Yes mate for the daiwa black emblems. When fitted, they either were too tight to put standard 15lb line under or were more loose than a wizard's sleeve. Shocking. Tbf, a full refund was not quibbled about.
|
|
|
|
In reply to Post #7
We’re these line clips for the Emblems mate?
|
|
|
|
In reply to Post #6
I use Weston qd replacement spool caps with carbon washers, perfect. I also replaced the line clips which are sold on Ebay by southern custom reels.....shocking....returned them the following day and got full refund.
|
|
|
|
In reply to Post #3
I’ve got same reels bud, just ordered some self fit line clips off eBay, didn’t know you could get carbon washers for them, sounds good.
|
|
|
|
In reply to Post #1
Roy (Carbontex) is a member of my syndicate mate, i dont own a set myself but from what i understand he is quite reputable in the carbon washer trade.
|
|
|
|
In reply to Post #3
I done my xtds wish the carbon washers from south custom reels, relatively inexpensive and very easy to do, would recommend to anyone
|
|
|
|
In reply to Post #2
Daiwa Emblem blacks
The kits I've seen on ebay do what you do or just replace the existing washers with carbon ones so the drag tightens up a lot quicker
|
|
|
|
In reply to Post #1
Don’t know what reels you have but a good few weeks ago I done my Fox 10000FD Reels because of the amount of turns
I removed the small plastic cap that housed the spring and a washer in the drag knob, I replaced the spring with a few washers that I got from B&Q until level as per spring
Works an absolute treat
|
|
|
|
Has anyone done their own QD conversions using the washers or kits that are available on the likes of ebay
Particularly looking at the sets of carbontex washers to replace the original ones
Cheers
|
|
Tackle